LG 20LH1DC1 Installation And Operating Manual page 69

CLONING PROCEDURE TROUBLESHOOTING
Clone not working
Clone programmer problem.
Clone Scans Channels more than once.
Clone should only scan
channels once.
Master and Other 20LH1DC1
Cloning did not work.
Procedure interrupted.
Different TV models.
Step(s) omitted or not
performed.
Insufficient cloning time.
Cloning erratic.
Clone time disappeared.
Batteries were removed.
New Setup not present
20LH1DC1 not reset.
• After cloning operations are complete, just unplug the LT2002 from the 20LH1DC1.
• If the 20LH1DC1 does not display a picture on the TV (blank screen) after a few seconds, just change channels.
Try a different LT2002 Clone programmer.
8
Reset Clone Programmer.
8
Retry cloning again.
8
Wait until procedure complete message is displayed.
8
Cloning is only possible with identical model TVs.
8
Reread 52 - 53 - 54 pages to be sure all tasks were performed.
8
Redo cloning and be sure learning/teaching time is about 1 min. and 5 to15 seconds (75 seconds).
8
Reset Clone Programmer.
8
Batteries must remain installed to retain time settings.
8
Disconnect newly cloned unit from power for 5 seconds.
8
69