Page 1
U S E R ’ S°Ø G U I D E Two-Way FM Remote M100AS USER’S GUIDE M100AS...
Page 2
Thank you. Thank you for your purchase of an M A G I C A R alarm and/or remote-start sys- t e m. M A G I C A R alarms and remote-start systems are the most advanced sys- tems o n th e mark et with amazing featu res, incomparable ease of use, a n d breakthrough technologies never before used in the automotive environment.
Before using your Magicar system, please take some time to familiarize MAGICAR LCD Screen yourself with it. Remote Description F ro n t°Ω °º LCD ICONS Timer Function On ¶UTurbo Function On ¶UPassive Function On ¶UAuto-mode 1 (Range: XX feet) °º...
Page 4
On - Impacts to the vehicle will be ignored by the alarm. Valet mode is on, only the door lock function will be ¶UOff - Impacts to the vehicle, depending on the severity, a v a i l a b l e . will trigger the alarm.
Button Functions Functions of Buttons Locking/Arming the vehicle and alarm. Buttons Functions 0.5sec ¶UArming(Lock) / Disarming (Unlock) If the system is unlocked/disarmed, pressing button I for a half second will lock the 0.5sec ¶UActivates AUX 1 output. doors and arm the alarm. This function will still operate even while the vehicle is 0.5sec ¶UActivates AUX 2 output.
Button Functions Button Functions Unlocking/Disarming the vehicle and alarm. 3. RPS Car Call Display ¶U When disarming, if the RPS was triggered while the system was armed, the If the system is locked/armed, pressing button I for a half second will unlock the numbers of times it was triggered will be displayed.
Page 7
Button Functions Button Functions AUTO Mode (ON/OFF) AUX Mode Entry (ON/OFF) Pressing button I for 2 sec. will turn on Auto mode. With Auto mode, the vehicle will As you enter AUX mode, the icon will be displayed. If an auxiliary channel is not unlock/disarm when the remote is getting closer, and lock/arm when the remote is far triggered within 60 sec., Aux mode will be cancelled.
Page 8
Button Functions 1. Extension of Remote Start Timer Remote Start (ON/OFF) The vehicle will start and run for a preset time if button II is pressed for 2 sec. If ¶UDuring the running time, if you press button I for 2 sec. °∞ Start-Again°± the vehicle is a diesel, the system will pause for a moment after turning on the igni- will scroll across the screen once and the timer will be reset to the preset time.
Button Functions Button Functions Trunk Release Query Function The trunk will be opened/unlocked, if a button III is pressed for more than 2 sec. If If button I V is pressed for 0.5 sec., the remote and vehicle will respond with the alarm is on, it will disarm and unlock the doors as well.
Page 10
Button Functions Button Functions Panic Mode four seconds Valet Mode ON/OFF If button I V is held for more than 4 sec., Panic mode will be initiated. The doors will I + I I I Activate Valet mode by pressing buttons for 0.5 sec.
Page 11
Button Functions Button Functions Shock Sensor ON/OFF Passive Arming ON/OFF ¶U I+ I I I To turn off the shock sensor, press buttons for 2 sec. Passive Arming, which will lock/arm the vehicle if it is disarmed, after 30sec, can be ¶UThe shock sensor is turned off if the [ ] icon is displayed on the LCD of the II + III...
Page 12
Button Functions Button Functions Parking Timer ON/OFF Timer Start Reservation ON/OFF 1. Parking Timer II + I V Timer start reservation is activated by pressing buttons at the same time for 0.5 ¶UThe Parking Timer can be used to monitor the time passed while driving or being sec if timer has been set up.
Button Functions Button Functions ¶UIn the case the door is unlocked in the middle of turbo operating, engine will shut Car Finder Mode Double Tap off in 20 seconds assuming that owner will be ready to drive the vehicle. Use this function if it is not easy to find your vehicle in a crowded place such as a 1.
Button Functions Option Functions Button Hold Function Warning of vehicle battery drain. 2 sec This function prevents accidental button presses while carrying your remote. If the vehicle is locked (armed) with a taillight on, the parking lights will flash once and siren will chirp 7 times 1.
Set-up and Other Functions Set-up and Other Functions Shock Sensor Trigger Code Unlock Function If the alarm is armed and the shock sensor is triggered by an impact to the vehicle, the Enter the four numbers (1111~9999) as a password, by using a RPS sensor, entering following sequence will occur: the correct pass code will unlock the doors, without either remote control or Key.
Set-up and Other Functions In Range Display Knocking (For door open or entering the password.) The password should be entered under the, °∞ car conditions for entering a password°± In Range Display Method (see page 28). If the remote and vehicle are within operating range of each other, the signal strength will be displayed beside the antenna icon on the display.
Set-up and Other Functions Set-up and Other Functions Time information backup GAS(LPG) Option Set-up 1. It saves time information (current time, start-up reservation time and alarm time) °ÿ Bu rning off gas residue in the sy stem: in the status where power has not been supplied to remote (at a time of replacing ¶U batteries).
Page 18
Set-up and Other Functions °‹When this product is installed in a manual transmission vehicle, Remote Start Reservation Mode for Manual Transmission Vehicles it must be set to Manual Transmission Mode. Our company is not responsible for any accident resulting from selecting wrong Reservation Mode prevents a manual transmission vehicle from starting in gear if the mode (Automatic Transmission Mode) for a Manual system has been installed properly.
Page 19
Set-up and Other Functions Set-up and Other Functions Reservation Mode Cancellation in Manual Transmission Vehicles Setting the Shock Sensor Sensitivity ¶U After Reservation Mode has been set up, it will be cancelled if either the trunk or a Controlling Shock Sensor Sensitivity door is opened.
Menu Options B u t t o n F u n c t i o n Application Method The °∞ °± icon flashes. Set-up of Remote Options H o u r Set-up of At this time, button will control the hour, and Present time ®x Entering the Main Menu...
Page 21
Menu Options Button Functio ns Once You are in the Programming Men u Set-up of Main Option ®x Button You can access Option Table 1 by pressing buttons for more than 2 sec. at the I I I same time. For 0.5 sec for 2.5 sec °„...
Page 22
E x a m p l e : If the remote start runtime of option 1-03 is to be set up as 3 min; _ Press buttons I + II for more than 2 seconds. (The remote will beep, and scroll: °∞...