Installing The Batteries To The Remote; Connect Power & Antenna/Cable/Satellite; Switching On/Off; To Switch The Tv On - Sharp LC-32LE352E-BK Operation Manual

Installing the Batteries to the Remote

1. Lift the cover on the back of the remote upward
gently.
2. Install two AAA batteries. Make sure to match the +
and - ends of the batteries in the battery compartment
(observe the correct polarity.
3. Replace the cover.
Connect Power & Antenna/Cable/Satellite
IMPORTANT: The TV set is designed to operate on
220-240V AC, 50 Hz socket. After unpacking, allow
the TV set to reach the ambient room temperature
before you connect the set to the mains. Plug the
power cable to the mains socket outlet.
13V dc/18V dc
VGA
SPDIF

Switching On/Off

To Switch the TV On

Connect the power cord to the 220-240V AC 50 Hz.
Switch the " " button on the bottom right hand side
under the screen to position "|" so the TV will switch
to standby mode. Then the standby LED lights up.
To switch on the TV from standby mode either:
• Press the " " button, P+ / P- or a numeric button
on the remote control.
• Press the " " or P/CH+/- button on the TV.
The TV will then switch on.
Note : If you switch on your TV via P+ / P- buttons on the
remote control or P/CH+/- on the TV set, the programme that
you were watching last will be reselected.
To Switch the TV to Standby
To switch the TV to low power stand by press the
" " button on the remote control or on the TV.
A01_[GB]_mb95_4847uk_DVBT_C_S2_DLNA_HBBTV_MMH_32205LED_39205LED_GOLD19_10081423-10081425-10082975-10083449_50231035_basic IB.indd 12 A01_[GB]_mb95_4847uk_DVBT_C_S2_DLNA_HBBTV_MMH_32205LED_39205LED_GOLD19_10081423-10081425-10082975-10083449_50231035_basic IB.indd 12
Note: When the TV is switched to standby mode, standby LED
can blink to indicate that features such as Standby Search,
Over Air Download or Timer is active.

To Switch the TV Off

Switch the "
under the screen to position 2 as illustrated,
isolate the TV from the mains, the LED will go
out.
When turned on for the fi rst time, the "language
selection" menu appears. The message "Welcome
please select your language!" is displayed in all
language options listed alphabetically.
Satellite
Aerial or Cable
DiSEqC
Switch Press the "
language, press OK button to select. "First Time
Installation" appears. Use "
required country, and press "
Type. Use "
Available search types are Digital and analog, digital
only and analog only. When set, press "
Teletext Language. Use "
"Teletext Language" and select "Scan Encrypted" using
"
Yes if you want to scan coded stations.
English - 12 -
" button on the bottom right hand side

First Time Installation

" or " " button to highlight the required
" or " " to set the desired search type.
" or "
" or " " button. You can set Scan Encrypted as
, to
" or " " button to set the
" button to select Search
" to select
" button to set the
29.01.2013 18:37:51 29.01.2013 18:37:51