Table of Contents
Advertisement
Notes for the installer
The machine can be levelled by adjusting the
screw feet.
Once levelled the discs must be turned with a
screwdriver against the machine's base plate.
The electrical connections to the dryer must
be in accordance with instructions given on
the installation diagram and comply with local
regulations.
Once installed in position all detachable outer
casing parts must be attached again.
Electrical connection
This machine has been constructed in accord-
ance with current safety standards and com-
plies with the following standards:
T 6251 and T 6351 with IEC 335-1 and IEC
335-2-11,
T 6551 and T 6751 with EN 60204-1
The electrical connection may only be carried
out by a fully competent person in accordance
with local and national safety regulations.
Connection must be made by a suitable isola-
tor and the on-off switch should be easily
accessible for servicing work.
WARNING
THIS APPLIANCE MUST BE EARTHED.
Follow instructions given on the enclosed wir-
ing diagram (with the machine on the terminal
block). These are important for the correct
electrical connection to be made.
WARNING
Ensure that the ventilation motor is turning in
the correct direction. To do this open the
panel to the fluff filter. The ventilation motor
must turn clockwise.
The dryer may only be connected to the same
voltage and rated load as shown on the data
plate.
The electrical rating is usually set ex works as
follows:
13.5 kW
18.0 kW
27.0 kW
36.0 kW
The gas heated version, T6251 must be con-
nected via an isolator.
Ensure the leads for N and phase L are cor-
rectly connected. Do not transpose.
All removable outer housing parts must be re-
fitted after the electrical connection has been
made.
23
T6251
T6351
T6551
T6751
«M.-Nr.04989220/02 - GB - »
Hide quick links:
Advertisement
Table of Contents
