Toe Grille; Defrost Timer (21 Cu. Ft.); Defrost Timer (23/26 Cu. Ft.); Lower Door Hinges - Amana V Series Service Manual

Disassembly
To avoid risk of electrical shock, severe personal injury or death; disconnect power to unit before servicing, unless
testing requires power. Discharge capacitor through a 10,000 ohm resistor before handling. Wires removed during
disassembly must be placed on the correct terminals to ensure proper grounding and polarization.

Toe Grille

1. Grip grille firmly at both ends.
2. Pull straight out, away from unit.
3. Reinstall by pushing toe grille straight back into its
mounting clips.

Defrost Timer (21 cu. ft.)

NOTE: Electronic units have no defrost timer.
1. Remove toe grille.
2. High-voltage (HV) box is screw-mounted at right side
of condenser coil. Remove mounting screw and pull
HV box out so it's accessible.
3. At top front of HV box, remove screw that secures
lid.
4. At right side of HV box, remove defrost timer
mounting screw.
5. Disconnect wires from defrost timer and remove
timer from HV box.
6. Reverse procedure to reinstall defrost timer.
RS1300004 Rev. 1
!
WARNING
Toe grille
Screw
Defrost timer
Contents of high-voltage box;
21 cu ft, non-electronic side x sides

Defrost Timer (23/26 cu. ft.)

1. Remove toe grille. Find timer box mounted in front of
condenser, just left of center.
2. Remove screws from timer-box lid and remove lid.
3. Remove defrost-timer mounting screws from lid of
timer box.
4. Disconnect wires from timer and remove timer.
5. Reverse procedure to replace timer.

Lower Door Hinges

1. Remove refrigerator and/or freezer door.
2. Remove toe grille.
3. Remove two lower-hinge mounting bolts from each
hinge.
4. Remove hinge(s).
5. Reverse procedure to replace hinges.
42
Lid
Motor capacitor
Foam gasket
HV box
Machine compartment
wiring harness
Screw