Viewing Camera Images - Panasonic BL-WV10A Setup Manual

Adding More Cameras to the System
Up to 8 cameras can be registered to the BL-WV10A. If you purchase additional
cameras later, you can register them by setting the mode switch of the BL-WV10A
to [SETUP], then turning the unit off and on again. The Quick Setup utility will
begin, and you can then follow the same procedure used to register your existing
cameras.

Viewing Camera Images

To start up the BL-WV10A to view camera images, make sure the mode switch on
the rear of the unit is set to [NORMAL] and turn on the BL-WV10A. The startup
screen will appear. If the [Date and Time] screen appears, set the date and time,
then press [ENTER]. The camera image should then appear.
While camera images, you can aim
the camera by panning and tilting the
lens using the navigator keys.
Pressing [DISPLAY] repeatedly
displays different camera and image
information.
Pressing [ENTER] aims the camera at
the camera's Home Position.
Pressing buttons [1]-[4] aims the
camera at one of the Preset Positions.
You can change the 4 preset positions
and register 4 additional Preset
Positions (5-8) as well.
For more information, see "Viewing
Camera Images" on page 54 of the
Operating Instructions.
[DISPLAY]
Navigator keys
[ENTER]
17