Table of Contents
Advertisement
Q u i c k
Change the 7875 program by scanning the proper sequence of
programming tags included with the unit. To make program
changes:
1. Enter the Base Programming state by scanning the Program-
ming Mode tag; this must be the first tag scanned after apply-
ing power.
2. Select a Programming Worksheet and enter its parameter data
by scanning the appropriate Hex tags.
3. Save the program by scanning the Save and Reset tag.
Note:
In most cases the factory-determined defaults are the
correct parameter setting. However, if you do need to
make changes, first set all parameters to default values,
then make any necessary changes to the appropriate pa-
rameters.
Scan Sample Tags
Scan some sample tags to verify that the 7875 is communicating
with the host terminal. Following are four tags that you can use,
providing the programming options are enabled.
R e f e r e n c e
21
Advertisement
Table of Contents
