Pioneer X-Z9 Operating Instructions Manual page 39

Additional information
Tuner
Problem
Considerable noise in radio
broadcasts.
Auto tuning does not pick up
some stations.
Sound is mono only.
Home Media Gallery
Symptoms
Cannot access the network.
Playback does not start while
'Connecting...' continues to
be displayed.
The PC or Internet radio is not
properly operated.
Remedy
• Connect the antenna (see Connecting the AM and FM antennas on page 10).
• Fully extend the FM wire antenna, position for best reception, and secure to a wall.
• Connect an outdoor FM antenna (see Connecting external antennas on page 10).
• Adjust the direction and position for best reception.
• Connect an additional internal or external AM antenna (see Connecting the AM and FM
antennas on page 10).
• Turn off any other equipment that may be causing the noise or move it away from the unit.
• Place the antenna farther away from any other equipment that may be causing the noise.
• The radio signal is weak. Auto tuning will only detect radio stations with a good signal. For
more sensitive tuning, connect an outdoor antenna.
• Check that the tuner is not set to FM mono (see Connecting external antennas on
page 10).
Causes
The LAN cable is not firmly connected. Firmly connect the LAN cable (see page 20).
The router is not switched on.
Internet security software is currently
installed in the connected component.
The audio component on the network
which has been switched off is
switched on.
The component is currently
disconnected from this receiver or the
power supply.
The corresponding IP address is not
properly set.
The IP address is being automatically
configured.
Remedies
Switch on the router.
There are cases where a component with Internet
security software installed cannot be accessed.
Switch on the audio component on the network
before switching on this receiver.
Check whether the component is properly
connected to this receiver or the power supply.
Switch on the built-in DHCP server function of
your router, or set up the network manually
according to your network environment.
See the separate 'Network Setup Guide'.
The automatic configuration process takes time.
Please wait.
11
39
En