Prop 65 Warning; Hazard: Explosion Or Fire; Hazard: Hazardous Vapors; Extension Cords - Homeright FINISH MAX PRO Instruction Manual

IMPORTANT SAFEGUARDS (CONTINUED)
WARNINGS
SERVICING A DOUBLE-INSULATED PRODUCT
In a double-insulated product, two systems of insulation are provided
instead of grounding. No grounding means is provided on a double
insulated product, nor should a means of grounding be added to the
product. Servicing of a double-insulated product requires extreme care
and knowledge of the system and should only be done by qualified service
personnel. Replacement parts for a double-insulated product must be
identical to those parts in the product.
CAUTION
1. HAZARD: Solvent and paint fumes can explode or ignite, causing
property damage and severe injury. Avoid all low ignition sources such
as static electricity, sparks, and open flames.
2. HAZARD: Paints, solvents, insecticides, and other materials may be
harmful if inhaled, causing severe nausea, fainting, or poisoning.
3. HAZARD: Do not hold cord at plug connections to support cord. Failure
to observe may result in electrical shock.

PROP 65 WARNING

Handling the coated electrical wires of this product exposes you to lead, a
chemical known to the State of California to cause birth defects or other
reproductive harm. Wash hands after use.

HAZARD: EXPLOSION OR FIRE

Paint, stain and solvent fumes can explode or ignite, causing property
damage and/or severe injury.
Do not use materials with a flash point below 70°F (21°C). Flashpoint is the
temperature that a fluid can produce enough vapors to ignite.
Plastic can cause static sparks. Never use plastic to enclose the spray
area. Do not use plastic drop cloths when spraying flammable materials.
• Keep area well ventilated. Exhaust and introduce fresh air to keep fumes
from accumulating in work area.
• Do not spray in areas where there are ignition sources, static electricity,
sparks, pilot lights, heaters, hot objects, cigarettes, or open flames.
• Have fire extinguishing equipment present and in good working order.
• Follow safety instructions and IMPORTANT SAFEGUARDS of material
manufacturers.
FINISH MAX PRO FINE FINISH SPRAYER

HAZARD: HAZARDOUS VAPORS

Paint, stain and solvents, insecticides, varnishes, and other materials may
be harmful if inhaled, causing severe nausea, fainting, or poisoning.
• Use a mask or respirator when spraying when there is a chance of
inhaling vapors.
• Use protective eyewear.

EXTENSION CORDS

Make sure your extension cord is UL/ETL/CSA listed and is in good
condition. When using an extension cord, be sure to use one heavy enough
for the current - for lengths less than 18 feet, use a No. 18 AWG. or
heavier; for lengths of 18 - 25 ft, use No. 16 AWG. For lengths greater than
25 ft, use No. 14 AWG. If in doubt, use a heavier gauge. An undersized cord
will cause a drop in line voltage resulting in loss of power and overheating
and possible damage.

STORAGE

Make sure unit is clean and dry before storing. Store in a dry location. To
prevent damage, the electrical cord should not be crimped during storage.
(C800850)
3
ENGLISH