Assembling The Trap In Four Steps - Biogents Mosquitare Instruction Manual

Assembling the trap in four steps

1. Open the BiogentsBasic dispenser (13) [F1] and place
it into the designated slot located on the inside wall of
the inner tube (8). [F2]
2. Place the funnel net (2) around the bottom of the
intake funnel (1). [F3] Then place the catch bag (3) over
the funnel net. The funnel net is now located inside the
catch bag. Tighten the top part of the catch bag about 2
cm below the top of the funnel net. [F4]
3. Insert the intake funnel with the attached funnel net
and catch bag [F4] into the opening on top of the trap.
[F5]
4. Insert the bottom of the CO2 emitter nozzle (10) into
the designated hole on top of the trap. [F6] The bottom
of the nozzle should fit into the middle opening.
F1
1
2
F3
F5
F2
1
2
3
F4
F6
EN 5