Getting Started - Motorola StarTAC SC200 Owner's Manual

1. Plug the telephone line cord into the socket marked
on the underside of the base.
2. Plug the power adaptor into the socket marked
the underside of the base and plug the other end into
the mains power wall socket. Switch on the
mains power.
3. Plug the curly cord into the corded handset and the
telephone base.
Connecting the charger and charging the
cordless handset
1. Plug the power adaptor into the socket marked
the underside of the charger and plug the other end
into the mains power wall socket.
2. Remove the battery cover from the back of the
handset and insert the 2 x AAA NiMH rechargeable
8
batteries supplied. Please note the '+' and '-' markings
inside the battery compartment and insert in the
correct direction.
on
3. Clip the battery cover back into place.
4. If you are charging the batteries for the first time,
place the handset on the charger to charge for at least
24 hours continuously.
5. The display will show the handset name and number
to indicate that it is registered to the base.
IMPORTANT
Warning! Use only the approved rechargeable Ni-MH
on
battery cells (2 x AAA Ni-MH 400mA rechargeable
batteries) supplied with your SC200.
BATTERY LOW WARNING
If you hear a warning beep every 30 seconds during a
call, you will need to recharge the handset before you can
use it again.
BATTERY PERFORMANCE
In ideal conditions, fully charged batteries should give up
to 7 hours talk time or up to 130 hours standby time on a
single charge.
1
Note that new batteries do not reach their full capacity
until they have been put to normal use for several days.
To keep your batteries in the best condition, leave the
Getting started