Makita 3601B Instruction Manual page 6

2
1
001985
Straight guide (optional accessory)
005043
The straight guide is effectively used for straight cuts
when chamfering or grooving.
To install the straight guide, insert the guide bar into the
holes in the tool base until the notch in the guide bar
reaches just under the wing bolt (B). Then tighten wing
bolt (B). Loosen the wing bolt (A) and adjust the distance
between the bit and the straight guide. At the desired
distance, tighten the wing bolt (A) to secure the straight
guide in place.
1 2
4
3
005044
When cutting, move the tool with the straight guide flush
with the side of the workpiece.
Templet guide (optional accessory)
005045
1. Feed direction
3
2. Bit revolving
direction
3. Workpiece
4. Straight guide
4
1. Wing bolt (B)
2. Wing bolt (A)
3. Straight guide
4. Guide bar
The templet guide provides a sleeve through which the
bit passes, allowing use of the tool with templet patterns.
To install the templet guide, screw the templet guide on
the base plate.
1
005046
1
2
3
4
5
6
003695
NOTE:
The workpiece will be cut a slightly different size
•
from the templet. Allow for the distance (X)
between the bit and the outside of the templet
guide. The distance (X) can be calculated by using
the following equation:
Distance (X) = (outside diameter of the templet
guide - bit diameter) / 2
Trimmer guide (optional accessory)
005047
Trimming, curved cuts in veneers for furniture and the
like can be done easily with the trimmer guide. The
guide roller rides the curve and assures a fine cut.
Install the trimmer guide on the tool base with the wing
bolts (B). Loosen the wing bolt (A) and adjust the
distance between the bit and the trimmer guide by
turning the fine adjusting screw (1.5 mm or about 1/16"
per turn). At the desired distance, tighten the wing bolt
6
1. Base plate
2. Templet guide
2
1. Bit
7
2. Base
3. Templet
4. Workpiece
5. Distance (X)
6. Outside
diameter of the
templet guide
7. Templet guide