Table of Contents
Advertisement
Turning Your Phone On and Off
Turning Your Phone On
To turn your phone on:
Press and hold
Once your phone is on, it may display "Searching for Service," which
indicates that your phone is searching for a signal. When your phone
finds a signal, it automatically enters standby mode – the phone's idle
state. At this point, you are ready to begin making and receiving calls.
If your phone is unable to find a signal after 15 minutes of searching, a
Power Save feature is automatically activated. When a signal is found,
your phone automatically returns to standby mode.
In Power Save mode, your phone searches for a signal periodically
without your intervention. You can also initiate a search for Sprint PCS
Service by pressing any key (when your phone is turned on).
Tip:
The Power Save feature helps to conserve your battery power when
you are in an area where there is no signal.
Turning Your Phone Off
To turn your phone off:
Press and hold
down animation on the display screen.
Your screen remains blank while your phone is off (unless the battery
is charging).
Section 2A: Your Sprint PCS Vision Phone – The Basics
for approximately two seconds.
END
for two seconds until you see the powering
END
15
Advertisement
Table of Contents
