Panasonic KX-A406 Installation Manual page 17

2
Turn on the repeater you want to register by connecting the AC adaptor.
The STATUS indicator and the RSSI/ID indicator will turn amber for 2 seconds.
3
When the repeater is unregistered:
The STATUS indicator will flash red, and the repeater automatically enters Easy Registration mode.
When the repeater is registered:
The repeater automatically enters Operation mode.
4
Press and hold down the PROGRAM button for 5 seconds.
The STATUS indicator will flash green quickly.
5
Release the PROGRAM button to enter Manual Registration mode.
The STATUS indicator will turn green.
The RSSI/ID indicator will flash red once to indicate that the ID is currently set to 1.
6
If the ID of the destination repeater was not 1, press the PROGRAM button to select the ID that
matches the destination repeater.
The ID will change by one each time the PROGRAM button is pressed. (e.g., If you select ID3 by
pressing the button 2 times, the RSSI/ID indicator will flash 3 times.)
7
Press and hold down the PROGRAM button for 5 seconds to assign the ID to the repeater.
The RSSI/ID indicator will turn red.
8
Release the PROGRAM button to reset the repeater.
The STATUS indicator and the RSSI/ID indicator will turn amber for 2 seconds and then the STATUS
indicator start flashing red. The repeater will then start searching for a repeater with the assigned ID.
9
When the repeater has found a repeater with the assigned ID, the STATUS indicator will turn green.
Registration is complete.
De-registration
Perform de-registration to delete the ID of the CS/repeater that the repeater is registered to.
1
While pressing and holding down the PROGRAM button (Page 11), turn on the repeater by
connecting the AC adaptor.
2
Continue to hold down the PROGRAM button for 10 seconds.
When the STATUS indicator turns red, de-registration is complete.
Note
If the PROGRAM button is released after 5 seconds but before 10 seconds have elapsed, while the
STATUS indicator is flashing red quickly, the repeater will enter Site Survey mode.
3
Release the PROGRAM button to reset the repeater.
The repeater automatically enters Easy Registration mode. For details about the easy registration
procedure, refer to "Easy Registration".
1. Linking to Cell Stations
17