Maintenance - Bosch HMV5052C Use And Care Manual

Part
Glass turntable tray
Turntable roller rest
Door glass
Painted surfaces
Stainless steel sur-
faces
Plastic & Controls
Printed areas
(words & numbers)
Cleaning the oven vent filters
The oven ventilation filters should be removed and
cleaned often; generally at least once every month.
CAUTION
9
To avoid risk of personal injury or property damage,
do not operate oven vent without filters properly in
place.
To remove the ventilation filters, slide the filter to the
1.
rear. Then pull filter downward and push to the other
side. The filter will drop out. Repeat for the 2nd filter.
Soak the ventilation filters in hot water using a mild
2.
detergent. Rinse well and shake to dry. Do not use
ammonia or wash in a dishwasher. The aluminum on
the filter will corrode and darken.
To reinstall an oven ventilation filter, slide it into the
3.
side slot, then push up and toward oven to lock.
Reinstall the 2nd filter using the same procedure.
Recommendations
Remove glass turntable tray from the oven when cleaning the oven cavity and tray.
NOTICE: To prevent the glass turntable from breaking, handle with care and do not put it in
water immediately after cooking.
Wash the glass turntable tray in warm soapy water or in the dishwasher.
Clean with warm, soapy water. Rinse thoroughly and dry.
Wash with soap and water or glass cleaner. Use Fantastik
sponge or paper towel and wipe clean. Avoid using abrasive cleaners, like powder cleaning
agents, steel wool pads and oven cleaners.
If steam accumulates inside or outside the oven door, wipe with a soft cloth. Steam can
accumulate when operating the oven in high humidity and in no way indicates microwave
leakage.
Clean with hot soapy water or apply Fantastik
towel and wipe clean. Avoid using abrasive cleaners, like powder cleaning agents, steel wool
pads and oven cleaners.
Always wipe or rub in the direction of the grain. Clean with a soapy sponge, then rinse and
dry, or wipe with Fantastik
Magic and a soft cloth. Remove water spots with a cloth dampened with white vinegar. Do
®
not use any cleanser that contains chlorine as these may rust the stainless steel
When cool, clean with soapy water, rinse and dry.
Do not use abrasive cleaners or petroleum based solvents.
or Formula 409
®
sprayed on a paper towel. Protect and polish with Stainless Steel
®

Maintenance

Surface light replacement
CAUTION
9
To avoid risk of personal injury or property
damange, wear gloves when replacing the light
bulbs.
Unplug the microwave oven or turn off power at the
1.
main circuit breaker.
Remove the bulb cover mounting screws at both light
2.
positions under the microwave.
or Formula 409 on a clean
® ®
to a clean sponge or paper
®
21