Test Run - Haier AC12CS1ERA Operation Manual

Installation Procedure
MOUNT THE COVER PLATE AND THE INTAKE GRILL
1.Mount the cover plate (right)
(1) Cut a pipe exit hole in the right plate. This is only when
the pipe exits from the right side. This operation is not required
when the protrusion is on the top or rear.
Cover plate (right)
(2) Join the cover plate (right) and mount with screws.
31
2. Mount the cover plate (left)
Join the cover plate (left) and mount with screws.

Test Run

Check items
1. Indoor unit
Is operation of each button on the remote control unit
normal?
Does each lamp light normally?
Do not air flow direction louvers operate normally?
Is the drain normal?
2. Outdoor unit
Is there any abnormal noise and vibration during operation?
Will noise, wind or drain water from the unit disturb the
neighbors?
Is there any gas leakage?
(2) Insert the hinges on the bottom of the intake grill into the
holes in the base assembly. Then mount the arms to the
three areas on the top of the intake grill.
3. Mount the intake grill.
(1) Cut the right side of the intake grill. This is only when
the pipe exits from the right side
Customer guidance
Explain the following to the customer in accordance with the
operating manual:
(1) Starting and stopping method, operation switching,
temperature adjustment, timer, air flow switching and other
remote control unit operations.
(2) Air filter removal and cleaning, and how to use air louvers.
(3) Give the operation and installation manuals to the customer.
17