Entering To Zone - Carrier 40RC003603 Owner's Manual

Multiple systems of the indoor units are set as a zone. Start/Stop control and every kind setting are available in each
zone. At shipment from the factory, one unit as one zone is set in 64 zones each.
(NOTE 1) If a unit is set to an incorrect zone, set the unit to the correct zone another time.
(The zone which has been finally set/entered is valid.)
(NOTE 2) A unit cannot be set to multiple zones.
(NOTE 3) While zone entering is set up, the unit which has been already entered is indicated with unit No. and " " in the
operation monitor indication part when zone No. is indicated.
Set up and entering
[Set up example]
Set Unit No. "1", "2", "3", "4", "5" to Zone No.1.
1
Push "ZONE SET/ENTER" button while "MONI-
TOR" is indicated.
Indication changes to [ZONE SET].
2
Pushing "ZONE" button indicates Zone No."1".
"SET", "ZONE", "UNIT" indications and the Unit
No. entered in the corresponding zone go on.
"1" is indicated at shipment from the factory.
Unit No.1 is set to Zone No.1.
3
Pushing "UNIT" button indicates Zone No."2".
"02" in Unit No. indication part and No."2" in
Operation monitor indication part flash.
4
When pushing "SELECT" button, the flashing
Unit No. in the operation monitor indication part
goes on.
3
Repeat steps and
4, and 5.
5
When "ZONE SET/ENTER" button is pushed,
the contents are entered.
(Unit No. and " " in the Operation monitor
indication part change to lighting .)
SET ZONE
1 2 3 4 5
END
Push "MONITOR/SET" button again. The Zone
set up completes and indication returns to
"MONITOR".
Indication returns automatically to "MONITOR"
after 15 seconds even if this step is not ex-
ecuted.

Entering to Zone

4
, and select Unit No. 3,
UNIT
MONITOR
UNIT
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32
33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48
49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64
MONITOR/SET ALL/ZONE ZONE UNIT
ZONE SET/ENTER SELECT
1
[ZONE SET]
ZONE
SET UNIT
1 2
MONITOR/SET ALL/ZONE ZONE UNIT
ZONE SET/ENTER SELECT
5 4 2 3
Every pushing " " buttons of ZONE and UNIT, indication No.
moves up by 1, and moves up successively by keeping
pushed. Every pushing " " buttons of ZONE and UNIT,
indication No. moves down by 1, and moves down succes-
sively by keeping pushed.
01 02 03
64 63 62
When setting another zone continuously,
2 3
repeat steps ,
ON
MODE FAN TEMP .
COOL HIGH
MODE TEMP.
ON CENTER/LOCKED FILTER RESET
FAN LOUVER
OFF TIMER ON
MODE TEMP.
ON CENTER/LOCKED FILTER RESET
FAN LOUVER
OFF TIMER ON
04 05 to 62 63
61 60 to 03 02
4 5
, , and .
ON
˚C
CHECK
ON
CHECK
64
01
7