Advertisement
User Manual
Command
UARTSW3
UARTSW4
Quit
Telnet Control
Before attempting to use telnet control, please ensure that both the C6 HDMI Matrix (via the ETHERNET
port) and the PC/Laptop are connected to the same active network.
Open a Command Prompt on your computer type telnet, then a space, then the IP address of the C6
HDMI Matrix, then another space, then 23 and finally press Enter.
Note: The IP address of the
Matrix
can be found by pressing the
MENU button twice. 23 is the TCP/IP
port for Telnet.
This will bring up the Telnet interface for the C6 HDMI Matrix. Type ? to list all the available commands,
please refer to the RS-232 & Telnet Commands section of this manual for a description of each
command.
Type IPCONFIG to show the complete IP configuration of the C6 HDMI Matrix. To reset the IP, type
RSTIP and to use a set static IP, type SETIP.
Note: All the commands will be not executed unless followed by a carriage return. Commands are case-
insensitive. If the IP is changed then the IP Address required for Telnet access will also need to be
change accordingly. A power cycle is also required for every IP change.
Web GUI Control
On a PC/Laptop that is connected to the same active network as the C6 HDMI Matrix, open a web
browser and type the device's IP address on the web address entry bar. The browser will display the
device's Status, Control and User Setting pages.
The Status page displays the C6 HDMI Matrix's current IP Configuration, Output Status and EDID Mode.
Action
Switch RS-232 control to output C and allow Matrix to send commands to
Receiver's connected RS-232 device.
Switch RS-232 control to output D and allow Matrix to send commands to
Receiver's connected RS-232 device.
Exit (for telnet only)
C6 HDMI
English
Advertisement
