Advertisement
User Manual
English
Rear Panel
1 RS-232
Connect to a PC or control system with D-Sub 9-pin cable for the transmission of RS-232 commands.
2 IP & ETHERNET
Connect to an active network for LAN serving and Telnet/Web GUI control. When the Matrix or any
compatible LAN equipped receivers are connected to a network, this allows the network access
(including internet access if available) to be shared between the Matrix and all connected LAN equipped
receivers. Connect any Ethernet equipped device such as a Smart TV or games console to the LAN port
of a receiver for that device to share the network/internet access.
Warning: Please do not connect this port directly to the PC/Laptop as the Telnet function will not work.
3 SERVICE
Manufacturer use only.
4 HDMI OUT and CAT5e/6 OUT A & C
Simultaneous HDMI and HDBaseT CAT5e/6/7 output. The HDMI output can be connected directly to a
HDMI Display for monitoring. Connect the CAT5e/6/7 output to a compatible receiver unit to extend the
signal up to 100m.
5 CAT5e/6 OUT B & D
Connect from these CAT outputs to the CAT input port of the receiver units with a single CAT5e/6/7
cable for HDMI Audio/Video and IR/RS-232 control signal transmission.
Warning: Please do not connect the CAT5e/6/7 output into the receiver's LAN port.
6 HDMI IN 1 – 4
Connect to the HDMI input source devices such as a DVD player or a Set-top Box with HDMI cable or
DVI to HDMI cable.
7 IR IN 1 – 4
Connect the IR extenders for IR signal reception. Ensure that the remote being used is within the direct
line-of-sight of the IR extender.
8 IR OUT 1 – 4
Connect the IR blasters for IR signal transmission. Place the IR blaster in direct line-of-sight of the
equipment to be controlled.
9 ALL IR OUT
Connect to the IR Blaster for IR signal transmission of the source or display equipment. Place the IR
blaster in direct line-of-sight of the equipment to be controlled.
10 ALL IR IN
Connect to the IR extender for IR signal reception of the remote control of this device or the source and
display equipment. Ensure that remote being used is within the direct line-of-sight of the IR extender.
11 DC 24V
Connect the 24 V DC power supply to the unit and plug the adapter into an AC outlet.
Advertisement
