Replacement Parts; Halogen Spotlight Replacement; Fuse Replacement Diagram; Specifications - Vector VEC271MG Owner's Manual & Warranty Information

4. Rubberized handle
5. Rubberized base
6. Rubberized bezel
7. Tools — (Hammer, Phillips screwdriver, Flathead screwdriver, Hex-
key set,
8. Reflector panel
9. Red LED flashing hazard light 12 volt power cord, with
10. 10 amp overload protection (Fuse located inside barrel)

5. REPLACEMENT PARTS

For replacement parts (bulbs, cords, fuses, etc.), contact Vector
Customer Service: (954) 584-4446 or toll-free (866) 584-5504.

5.1 HALOGEN SPOTLIGHT REPLACEMENT

• Pull rubberized bezel off spotlight.
• Unscrew the protective ring (2 small screws, Phillips
screwdriver needed.)
• Remove the lens carefully.
• Remove the rubber insulator.
• Remove the halogen bulb, by pushing 2 small wires together
and pull gently.
• Replace the bulb, make sure it is secure.
• Replace the protective ring and carefully tighten small screws.
• Push the black rubberized bezel back into place.

5.2 FUSE REPLACEMENT DIAGRAM

6. SPECIFICATIONS

MODEL VEC271MG Portable 1,000,000 Candle Power Spotlight and Tool Kit
BULB
POWER CORD
HEIGHT
LENGTH
6
Adjustable wrench and Slip-joint pliers)
Do not over tighten!
MAKE SURE FUSE IS REPLACED WITH SAME TYPE AND AMP
RATING. ELECTRIC SHOCK COULD RESULT IF DIRECTIONS ARE
NOT FOLLOWED.
Use with 12 volt DC vehicle accessory outlet
H3, 55 watt
8.5 in (21.6 cm)
15.5 in (39.4 cm)