20,000,000 power series sport spot 3 led auxiliary light 12 volt dc power supply cordless rechargeable (6 pages)
Summary of Contents for Vector VEC184POB
Page 1
VEC184POB POWER SERIES 2,000,000 SPOTLIGHT CORDED • CORDLESS • RECHARGEABLE IF YOU SHOULD EXPERIENCE A PROBLEM WITH YOUR PURCHASE CALL TOLL FREE (866) 584-5504. IN MOST CASES A SERVICE REPRESENTATIVE CAN RESOLVE YOUR PROBLEM OVER THE PHONE. KEY INFORMATION YOU SHOULD KNOW: •...
Page 2
NOTE: This unit is shipped in a partially charged state. Initial charge time is approximately 18-20 hours, 15 hours thereafter. IMPORTANT SAFETY INSTRUCTIONS WARNINGS: Contains non-spillable, sealed, lead-acid battery. Battery must be recycled or dis- posed of properly. For battery disposal information call toll-free (877) 288-7722. DO NOT dispose of batteries in fire, as this may result in an explosion.
Page 3
Two recharge adapters are supplied with the spotlight. It is rechargeable from either a 12 volt DC accessory outlet, or from any 120 volt 60 Hz AC outlet. This permits recharge flexibility for use around home, business or in the field. 12 volt DC power is available from most vehicles, boats, jump starters and portable battery packs.
Page 4
5.1 AC RECHARGE During Recharge: a) Never turn on while charging. b) Make sure that the AC power source is 120 volts, 60 Hz. c) After recharge – disconnect cord and wait 5 minutes before use. FIGURE 2 - AC CHARGER WARNING: Use the supplied AC recharge adapter;...
Page 5
6. PERIODIC MAINTENANCE All batteries lose charge over time, especially when they are warm. AC recharge is rec- ommended every two months, when not in frequent use. Use the AC recharger and charge for the recommended time. If the unit gets dirty gently clean the outer surface of the spotlight unit with a soft cloth moistened with a mild solution of water and detergent.
Page 6
FIGURE 5 - BULB ASSEMBLY BULB METAL PRONGS PHILLIPS HEAD SCREW METAL PRONGS PHILLIPS HEAD SCREW REFLECTOR Bulb life can be shortened by installing a bulb with dirt or fingerprints on it. During bulb installation, avoid touching the glass part of the bulb (see Figure 4 and 5 for details). 1.
4. Note polarity of battery. Note which color wire is on which terminal. 5. Disconnect the wires from the battery and set the battery aside. 6. Connect the replacement battery, making sure the correct color wires are on the new battery terminals.
Need help?
Do you have a question about the VEC184POB and is the answer not in the manual?
Questions and answers