Using The 3 Led Auxiliary Light; Replacement Parts; Using The 12 Volt Dc Accessory Outlet; Bulb Replacement - Vector Sport Spot 20,000,000 Power Series User Manual

Using the 3 LED Auxiliary Light

The 3 LED Auxiliary Light is operated by the LED Auxiliary Light ON/OFF Pushbutton
located on the top of the grip handle.

Using the 12 Volt DC Accessory Outlet

The 12 volt DC accessory outlet powers any DC appliance that does not exceed
5 amps. Flip up the accessory outlet cover and insert the appliance's DC plug. Close
the cover after use.

Using the Adjustable Workstand

Set the hands-free adjustable workstand to the desired position; then turn the knobs
on either side of the unit to lock in position.

CARE AND MAINTENANCE

All batteries lose charge with time. AC recharge is recommended after each use or
every two months when not in frequent use. Use the AC recharger and charge for
the recommended time.
If the unit gets dirty, gently clean the outer surfaces of the Spotlight with a soft cloth
moistened with a mild solution of water and detergent. Periodically inspect the
condition of recharge adapters, connectors, and wires. Replace any components
that may have become worn or broken.
4

Replacement Parts

The quartz halogen bulb and sealed lead acid batteries are available through Power
on Board. A comparable (12 volt H4 130 watt) bulb may be substituted. These can
also be purchased from popular automotive parts suppliers nationwide. Contact
Power on Board's Technical Support Department for replacement parts (including
replacement adapters and cords) and any additional information that you may need.
They may be reached at (954) 584-4446 or toll free at (866) 584-5504.
WARNING
To reduce the risk of shocks or burns and avoid damage to the unit,
make sure all power switches are in the OFF position, all adapters are
unplugged and the unit has been allowed to cool down before
performing any maintenance/parts replacement.

Bulb Replacement

1. Remove the rubber bezel on the rim of the Spotlight to reveal eight small Phillips
screws in the retaining ring.
2. Using a screwdriver, remove (counterclockwise) the screws and set them aside.
3. Lift off the retaining ring, glass lens and rubber "O" ring and set them aside.
4. Carefully remove the reflector and bulb assembly.
5. Disconnect the bulb from the guarding wires and replace the burned out bulb
with one of the same type listed in the Specifications section of this manual.
6. Reassemble the guarding wires, put back the reflector, rubber "O" ring and
the lens.
7. Replace rubber bezel by sliding forward to the front of the spotlight.
8. Turn one of the spotlight's ON/OFF switches to the ON position to ensure
proper operation of spotlight.
5