Dyson AM10 Operating Manual page 13

Some cleaning chemicals are harmful to the appliance
and should not be used. Use of these will invalidate
your guarantee. Do not use: Alcohol and strong acid
mixes, solvent (acetone) and oil based products, alkali
bleach mixes, air fresheners, aroma oils, scented oils,
hot water, brushes, abrasive materials, etc. Please do
not put in a dishwasher or close to a fire.
2
Using a damp cloth, wipe over both sections with
1
the citric acid solution. Do not put in a dishwasher
2
or rinse under the tap.
1
5
To remove the seal, pinch the securing tabs together and pull
out. Clean thoroughly by immersing in the recommended
citric acid solution for 15 minutes. Rinse and wipe over all
surfaces. Repeat if necessary. To refit, push back in so the
tabs click and the fit is secure.
dishwasher. Fill the trough with the recommended acid citric
solution until the UV-C emitter and piezo are submerged.
Leave for 15 minutes. Drain, rinse and wipe over all surfaces.
Repeat if necessary.
1
2
1
Piezo
15 mins
UV-C emitter
3
To attach the loop amplifier surround, lie flat
and align the surround to the main amplifier.
Push firmly until it clicks into place as shown.
6
Pour in the recommended citric acid solution. Replace the
cap and shake tank for 30 seconds. Then leave to stand.
After 15 minutes, empty the tank. Rinse and wipe over all
surfaces. Repeat if necessary.
8
Re-assemble. Wipe the exterior with a lint-free microfibre
cloth. Switch 'ON': the water treatment procedure starts.
After 3 minutes the appliance will start to humidify.
15 mins
13