Advertisement
Burn Hazard.
Do not touch hot food,liquid or heating surfaces
while equipment is heating or operating
Hot surfaces and food can burn skin. Allow the hot surfaces to cool
before handling
CLEANING
1. Always ensure that the unit is disconnected from the main
power supply before cleaning.
2. This unit should not be cleaned with a water jet or immersed
in water. Use only a damp cloth or sponge dipped in
soapy water.
3. Wipe off the unit with a dry cloth and wait at least a half
an hour before re-connecting to the main power outlet.
CLEAN THE STAINLESS STEEL PARTS WITH WATER
AND SOAP. AVOID THE USE OF DETERGENTS
CONTAINING ABRASIVE SUBSTANCES. ALWAYS
RINSE WELL AND DRY CAREFULLY AFTER
CLEANING. DO NOT USE PRODUCTS CONTAINING
AGGRESSIVE CHEMICALS, ACIDS OR PRODUCTS
WITH CHLORINE TO CLEAN THE STAINLESS STEEL
EVEN IF DILUTED
WARNING
Electric Shock Hazard.
Keep water and other liquids from entering the inside
of the equipment. Liquid inside the equipment could
cause an electrical shock
Do not spray water or cleaning products. Liquid could contact the
electrical components and cause a short circuit or an electrical shock.
Do not use equipment if power cord is damaged or has been modified
SAFETY
READ ALL INSTRUCTIONS BEFORE USE. FAILURE TO
FOLLOW THESE PRECAUTIONS COULD RESULT IN INJURY TO
YOURSELF AND OTHERS
1.
When this appliance is to be positioned in close proximity to a
wall, partitions, kitchen furniture, decorative finishes, etc.it is
recommended that they be made of non-combustible material.
If not, they shall be clad with a suitable non-combustible heat
insulating material, and the closest attention be paid to fire
prevention regulations.
2.
Use the multifunction warmer on an individual 15A mains outlet
only. DO NOT OVERLOAD THE CIRCUIT.
3.
Ensure that the equipment and the power supply cord does not
come into contact with hot surfaces.
4.
Supervision is necessary when the appliance is used in close
proximity to children.
5.
If the supply cord is damaged, it must be replaced with a new
cord assembly available from the suppliers agent. The cord
shall be an oil resistant sheathed flexible cable not lighter
than ordinary polychloroprene or equivalent synthetic
elastomer - sheathed cord (code designation 60245 IEC 57)
6.
Use only earthed outlets matching the serial plate voltage.
7.
Have equipment installed by a qualified personnel in accordance
with local codes and ordinances.
8.
Use equipment in a flat level position.
9.
Do not operate unattended
10. The equipment may be hot, even though the pilot light is not on.
11. Do not operate if equipment has been damaged or is malfunc-
tioning in any way.
12. These units are designed to run only on alternating current
(A.C.) DO NOT CONNECT TO DIRECT CURRENT (D.C)
WARNING
Advertisement
