Download Print this page

Anvil CDA1003 R01 Installation Operation And Care

Multifunction warmer

Advertisement

Quick Links

LIMITED WARRANTY
All equipment which is sold under ANVIL trademark and used for
commercial purposes is warranted against defects in materials and
workmanship. The warranty runs for one year from the date of origi-
nal installation and is for the benefit of the original purchaser only.
All other Warranties ,expressed or implied , statutory or otherwise,
including without limitations any implied Warranty of Merchantability
or fitness for purpose are excluded .The Seller shall in no event be
liable for direct,indirect or consequential damages in connection with
ANVIL commercial products.
The Sellers obligation under this Warranty is limited to the re-
pair of defects without charge. Defective units must be taken or
shipped,transportation charges prepaid,to ANVIL.
This Warranty is not effective if damage occurs because of
accident,carelessness,improper installation,lack of proper set-
up,supervision when required or if the equipment is installed or
operated in any manner contrary to the installation and operating
instructions. In these cases,repairs will be made at a reasonable
cost. Work performed by unauthorized personnel or unauthorized
service agencies voids this Warranty.
NB:
REGISTER ON-LINE TODAY
Register your warranty on-line now at www.anvilworld.com
NO WEB ACCESS
If you do not have access to the Web. Kindly register by completing
the warranty registration form and fax it to the ANVIL office in the
country of purchase.
Failure to do so will invalidate your warranty.
4-INS-CDA1003R01
MULTIFUNCTION WARMER
INSTALLATION OPERATION AND CARE OF
MULTIFUNCTION WARMER
MODEL: CDA1003 R01

Advertisement

loading

Summary of Contents for Anvil CDA1003 R01

  • Page 1 NO WEB ACCESS If you do not have access to the Web. Kindly register by completing the warranty registration form and fax it to the ANVIL office in the country of purchase. Failure to do so will invalidate your warranty.
  • Page 2: Installation

    UNPACKING MODEL: MULTIFUNCTION HEATING STATION MODEL CODE : CDA1003 R01 Unpack the product and check for any damage incurred during transit. This should be reported to the responsible carrier, railway or postal authority, and a request for a damage report should be made.
  • Page 3 EXPLODED DIAGRAM MULTIFUNCTION WARMER CDA1003 R01 CARVING STATION CONFIGURATION FIGURE 2 DRY HEAT BAIN MARIE CONFIGURATION FIGURE 3 CHIP DUMP CONFIGURATION...
  • Page 4: Operation

    ENERGY REGULATOR 1-ER-URS0012 TOP ELEMENT 5-1000W-CD CONTROL PANEL LAYOUT BOTTOM ELEMENT 5-1000W-CDA1003 PILOT LIGHT 1-PL-BMA0001 INDICATOR LAMP ENERGY REGULATOR CONTROL KNOB (3) 230V WIRING DIAGRAM MODEL CODE: CDA1003 R01 MODEL: MULIFUNCTION WARMER ILLUMINATED ROCKER MAIN SWITCH (1) SWITCH (2) TOP ELEMENT...
  • Page 5: Operating Tips

    OPERATING TIPS MULTIFUNCTION WARMER 1. Carving Station CDA1003 R01 When the unit is used as a carving station we recommend that the user adds approximately 20-25mm of water into the gastronorm insert. This will ensure that the product does not dry...
  • Page 6 WARNING WARNING Electric Shock Hazard. Burn Hazard. Keep water and other liquids from entering the inside Do not touch hot food,liquid or heating surfaces of the equipment. Liquid inside the equipment could while equipment is heating or operating cause an electrical shock Hot surfaces and food can burn skin.