Advertisement
POSITIONING DIAGRAM
MULTIFUNCTION WARMER
CDA1003 R01
121
346
579
681
OPERATING TIPS
1. Carving Station
When the unit is used as a carving station we recommend that
the user adds approximately 20-25mm of water into the
gastronorm insert. This will ensure that the product does not dry
out if left for extensive periods of time
using the top element as this too will dry out the product. The
product should be placed onto the perforated tray with the spikes
which will ensure that it is supported while it is being carved.
2. Chipdump
When using the chipdump we recommend that the chip portions
are never left longer than 20 minutes to ensure that they retain
their crisp form.
IT IS ESSENTIAL TO MAKE SURE THAT THE INCOMING
VOLTAGE IS THE SAME AS THE RATED VOLTAGE OF
THE OF THE UNIT AS FOUND ON THE SERIAL PLATE.
THE SERIAL PLATE IS LOCATED AT THE REAR OF THE
UNIT ADJACENT TO THE INCOMING CABLE ENTRY.
Additionally avoid
Advertisement
