Comfort Glow CGD3924NR Owner's Operation And Installation Manual page 13

INSTALLATION
Continued
INSTALLING LOGS
(CGD3924NR)
WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only
parts specifically approved with
this heater may result in property
damage or personal injury.
CAUTION: After installation
and periodically thereafter, check
to ensure that no flame comes in
contact with any log. If so, repo-
sition logs according to the log
installation instructions in this
manual. Flames contacting logs
will create soot.
Each log is marked with a number. These
numbers will help you identify the log when
installing. It is very important to install these
logs exactly as instructed. Do not modify
logs. Only use logs supplied with heater.
1. Locate pegs on the bottom of back log
(#1). Slide these pegs into the holes in
the grate base behind the burner (see
Figure 17).
2. Place the base of the middle log (#2) in
the U-shaped slots of the grate base in
front of the back log. The cutout on the
right of the middle log should fit over the
burner (see Figure 18). Make sure the
front of the middle log is resting on the
tabs of the grate base and the cutout area
is centered over the burner "U" bend.
3. Locate the recesses on the back of the
front log (#3). Fit these recesses be-
tween the posts of the grate base (see
Figure 19).
4. Locate the notches in the bottom of the
crossover log (#4). Place the crossover
log on top of the middle log and front
log. Make sure the notches of the cross-
over log lines up with rectangular knobs
on top of the middle and front logs (see
Figure 20).
5. Add lava rock around base of heater.
Do not place any lava rock on logs or
burner.
104306
Peg
Hole in
Grate Base
Figure 17 - Installing Back Log (#1)
Middle Log (#2)
Tab
Burner
Figure 18 - Installing Middle Log (#2)
13
OWNER'S MANUAL
Back Log (#1)
Post
Burner
Figure 19 - Installing Front Log (#3)
Notches
Cutout
Rectangular
Knobs
Figure 20 - Installing Crossover Log (#4)
"U" Bend
U-Shaped
Slot
Front Log (#3)
Recess
Post
Crossover Log (#1)
Continued