Extreme Networks Summit X150 Series Hardware Installation Manual page 182

Installing Summit Family Switches
To rack-mount a Summit switch:
1 Place the switch upright on a stable work surface.
2 Place a mounting bracket over the mounting holes on one side of the unit.
3 Insert the screws and fully tighten with a suitable screwdriver, as shown in
Figure 129: Attaching the Mounting Bracket
Summit X350, X450, X450a,
and X450e, series
4 Repeat steps 2 and 3
5 Slide the switch into the rack
Take care to load the rack so that it is not top-heavy. Start installing equipment at the bottom of
●
the rack and work up.
Do not cover vents that would restrict airflow. Leave half a rack space between the units for
●
adequate ventilation.
Figure 130: Installing a Switch in a Rack
'
6 Secure the switch with suitable screws (not provided).
7 Connect the switch to the redundant power supply (if applicable). For instructions to install and
connect redundant power supplies, see
182
34
35
S450_007
for the other side of the switch.
(Figure 130).
SH_236_X450
Chapter 2, "Summit Power Supplies."
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
49 X
Summit X150 and X250e series
Summit Family Switches Hardware Installation Guide
Figure 129.
50 X
SH_245_S150