HP omnibook xt6200 Reference Manual page 121

Main Menu
Setting
BIOS Revision
System Time
System Date
Internal Hard Disk
Video Configuration
Quiet Boot
Video Display Device
Video Expansion
Primary Video
Adapter
Television Type
System Memory
Extended Memory
Unique Dock ID
UUID
MAC Address
Serial Number
Service ID
Description
Shows the current BIOS version.
Sets the time using 24-hour format. Values set take effect
immediately.
Sets the date using dd/mm/yy format (except English, which
uses mm/dd/yy format).
Sets the hard disk drive type and various parameters.
Press ENTER to see or change the video settings below.
Press ESC to return to the main menu.
When enabled, hides summary of power-on self-test and
messages during boot.
Sets whether the built-in display automatically switches to an
external display, if one is detected.
When enabled, the video image covers the entire display in
lower resolution modes. When disabled, the video image is
centered in the display.
Sets whether the computer automatically switches to an
external video adapter connected to the docking system, if
one is detected.
Controls the signal format (NTSC or PAL) output by the
S-video port.
Shows the system memory size.
Shows the extended memory size.
Sets whether the computer creates a unique hardware profile
for each dock (Enabled) or uses a common profile for all
docks (Disabled).
Displays the value of the 16-byte UUID (Universally Unique
ID) as 32 hex characters.
Displays the MAC network address of the internal (wired)
LAN.
Displays the serial number as shown on the back of the unit.
Displays an identifier used for repair service.
Troubleshooting and Maintenance
Configuring the Computer
Default
Detected
automatically.
Detected
automatically.
Enabled
Auto
Disabled
Auto
NTSC
640 KB
Detected
automatically.
Enabled
Detected
automatically.
Detected
automatically.
Detected
automatically.
Detected
automatically.
Reference Guide 121