Table of Contents
Advertisement
Using the 20 second delay: Using the Installer-Programming for the system, change
the engine setting to "Diesel Engine," or use the CliffNet Wizard Pro installation soft-
ware to program the system. The CliffNet Wizard Pro will also allow you to customize
the delay to an interval other than 20 seconds.
h3/10 blue/green (+) shut down
1.
When the intellistart is programmed to Automatic transmission mode (H3/1
black/green is grounded), then connect the H3/10 blue/green wire to the vehi-
cles back up light wire. This wire should show +12V when the shifter is in
reverse, and show no voltage or ground when NOT in reverse.
2.
When the intellistart is programmed to Manual transmission mode (H3/1
black/green is NOT grounded) connect the H3/10 blue/green wire to the park-
ing brake indicator wire. The wire should show ground when the parking brake
is set, and +12V when the parking brake is NOT set.
h3/11 brake light input (+)
The IntelliStart monitors the brake light to prevent an unauthorized driver from driv-
ing the car. The brake light input wire MUST be connected and brake light must be in
working condition. This connection is not necessary if the alarm is already connected
to the brake with the H2/11 wire on the main control module (preferred).
h3/12 black/gray rpm input
This wire monitors the RPM of the vehicle during remote start sequence. Connect this
wire to the vehicle coil's negative side or the non-common fuel injector wire.
© 2003 directed electronics, inc.
21
Advertisement
Table of Contents
