H3 Harness Wire Connection Guide; Harness Wiring Diagram - Clifford Solaris 5 Installation Manual

Clifford solaris 5 remote start and auto security system

Hide thumbs Also See for Solaris 5:

Manual (49 pages)

Table Of Contents

Table of Contents

To test and determine the polarity of this wire:

Set your multimeter to DCV or DC voltage (12 or 20V is fine).

Attach the (+) probe of the meter to (+)12V.

Probe the wire that you suspect leads to the bulb with the (-) probe of the meter.

Turn the ignition switch to the ON position.

If the meter indicates 12 volts until the light goes out you have isolated the cor-

rect wire and the wire's polarity is negative (ground while the bulb is on).

If the meter reads zero volts until the light goes out and then reads 12 volts, you

have isolated the correct wire and the wire's polarity is positive.