Rena Ware AQUA II 5000 User Manual page 6

III. Installation
AQUA 3 II WATER FILTER PARTS:
A adapters—the optional
attachments used to connect the
diverter valve to the faucet
B base—contains flow meter and
supports manifold
C body-cover—the shell which
covers the two filter housings
D clamp—the small white device
which holds the inlet tube onto
the top barb of the diverter valve
E diverter valve barbs—the
extensions on the diverter valve
onto which the tubing is placed
F diverter valve—allows
convenient at-faucet switching
from tap to filtered water
G flow-meter—monitors the
number of liters of water treated
by the AQUA 3 II water filtration
system
H flow-meter viewing window—
allows you to view flow-meter
I housing wrench—used to
loosen the filter housings if they
become too tight to hand loosen;
never use the housing wrench to
tighten the filter housings.
J manifold—connects the pre-filter
with the main filter
K multi-media filter—provides
final multiple stage filtration of
water
L multi-media filter housing—the
white cylinder which covers the
multi-media filter
M O-rings—creates seal between
multi-media filter housing, pre-
filter housing and manifold
NOTE: Your Aqua 3 II 5000 will have either a spout or a double diverter
valve assembly, depending on the model.
6
(continued)
N pre-filter ceramic candle—acts
O pre-filter housing—the white
P pressure release valve—allows
Q scouring pad—used to clean
R small wrench—used to
S socket—openings where the
T tubing—the double tubing which
U tubing inserts—the inserts at
V tubing receptacles—the
W release button—press to
X spout—releases filtered water
Y elbow—attaches spout to tubing
Z single inlet tubing—connects the
as a pre-filter, providing initial
filtration of water before it passes
on to multi-media filter
cylinder which covers the pre-
filter ceramic candle
residual pressure to be released
from the pre-filter housing
the pre-filter ceramic candle
disconnect the tubing from
the tubing receptacles in the
manifold
filters are inserted
connects the diverter valve on
the faucet with the AQUA 3 II
water filtration system. The inlet
tube extends from the top barb
of the diverter valve to the tubing
receptacle marked (+) and is
marked with a black dashed line
the end of each tube
openings in the manifold where
the tubing is inserted, inlet (gray)
and outlet (white)
release the base from the main
unit
outlet receptacle
single diverter valve to the inlet
receptacle