Advertisement
III. Installation
Internal Components—
Filter Housings:
Never use the housing wrench to
tighten the filter housings—use it
only for loosening and removing
the filter housings. Housings
should always be hand-tightened
only.
III. Installation:
Your AQUA 3 II is a high
technology water filtration system.
It consists of a ceramic pre-filter
and main filter integrated by an
advanced manifold system. Your
AQUA 3 II will provide years of
good service when properly cared
for and maintained.
ALWAYS PROPERLY CLEAN
AND MAINTAIN YOUR AQUA 3 II
FOR BEST RESULTS.
READ ALL INSTRUCTIONS
PRIOR TO INSTALLATION.
Wash and dry your hands before
beginning installation and make
sure your work area is clean and
dry.
NOTE: Different diverter valves are used on the Aqua 3 II 5000,
depending on what country you live in. Some diverter valves have a pin
that is pulled or slides to enable water to be filtered, and others have
lever that needs to be turned. Installation is the same regardless of the
type of valve you have.
Remove all items from the box
and check each item against the
parts diagram (see parts list and
diagram on pages 6 and 7). Note:
You will find the small wrench
affixed to the handle of the housing
wrench. Hold the AQUA 3 II by the
base when removing from the box,
and place on the counter. Remove
the pre-filter ceramic candle from
its packing materials for the initial
installation.
WHEN HANDLING THE AQUA 3 II
UNIT, ALWAYS HOLD IT FIRMLY
AT THE BASE.
DO NOT ATTEMPT TO LIFT THE
AQUA 3 II BY THE BODY-COVER
OR THE TUBING.
To assist you in installing your
AQUA 3 II, you may wish to have
the following items available:
pliers, flat blade screwdriver,
petroleum jelly.
5
Hide quick links:
Advertisement
