Rena Ware AQUA II 5000 User Manual page 13

III. Installation
OPTIONAL SPOUT
INSTALLATION:
1. Insert the tubing insert (D) into
the end of the single tubing
(G).(See photograph 1).
2. Push the tubing into the
''+'' inlet receptacle on the
manifold, indicated by a "+"
symbol and gray collar. (See
photograph 2).
3. Push the white elbow (B) into
the outlet indicated by the "o"
symbol and white collar in the
manifold. (See photograph 3).
When properly installed, the
elbow will be almost flush to
the white collar.
4. Support the elbow from
underneath and push the
spout (A) firmly down into
the while elbow (B) (See
photograph 4).
5. Position the spout (A) straight
up and down. The spout
should rotate freely inside
the white elbow.
6. Run the cold tap water and
engage the diverter valve.
Note: Filtered water only
flows from the unit's spout;
tap water only flows from the
diverter valve.
(continued)
photograph 
photograph 
photograph 3
photograph 4
3