Setting Spool Pins; Winding The Bobbin - Janome Magnolia 7312 Instruction Manual

Janome 7312 Instruction Manual
z
x
vb
m
www.aaasewing.com

Setting Spool Pins

The spool pins are used for holding the
spool of thread in order to feed thread to
the machine.
To use, pull up the spool pin. Push down
for storage.

Winding the Bobbin

z Release stop motion knob by turning
x Draw the thread from spool.
c
c Insert the thread through the hole in
v Push it to the right.
b With the free end of the thread held in
n
n Depress the foot control again.
m Tighten stop motion knob by turning
10
it counterclockwise.
Guide the thread around the bobbin
winder thread guide.
the bobbin from the inside to the
outside.
Put the bobbin on the bobbin winder
spindle.
your hand, depress the foot control.
Stop the machine when it has made a
few turns, and cut the thread close to
the hole in the bobbin.
When the bobbin is fully wound, stop
the machine.
Return the bobbin winder spindle to
its original position by moving the
spindle to the left, and cut the thread.
it clockwise.
Magnolia 7312 Owners Manual/ User Guide
Janome Sewing Machine