Speed Limit - BMW M5 Owner's Manual

Displaying stored Check Control
messages
1. Press the button longer:
The first stored message is displayed.
2. Press the button:
When the button is pressed again, a differ-
ent message is displayed.
Via iDrive
iDrive, for operating principle refer to page 16.
1. "Vehicle Info"
2. "Vehicle status"
3. "Check Control"
4. Select the text message.
Displays after completion of trip
Malfunction reports generated during the trip
are shown consecutively when you switch off
the ignition.
Before the display disappears, you can display
the messages once again. Press the CHECK
button for approx. 2 seconds. If several mes-
sages are present, you can continue to press
the CHECK button to view them in succession.
The display goes out
> after a short time
68
Online Edition for Part no. 01 41 2 602 697 - © 08/09 BMW AG Online Edition for Part no. 01 41 2 602 697 - © 08/09 BMW AG
> when you press the CHECK button again
for approx. 2 seconds

Speed limit

You can enter a speed and a Check Control
message indicates when you have reached this
speed. This enables you, for example, to
receive warnings if you exceed a speed limit in
an urban area.
You are only warned of reaching this speed a
second time if your vehicle speed falls below it
again by at least 3 mph/5 km/h.
Displaying, setting or changing limit
iDrive, for operating principle refer to page 16.
1. "Settings"
2. "Limit"
3. "Limit:"
4. Turn the controller until the desired limit is
displayed.
5. Press the controller.
The speed limit is stored.
Applying your current speed as limit
iDrive, for operating principle refer to page 16.
1. "Settings"
2. "Limit"