Starting Engine - BMW M5 Owner's Manual

Hide thumbs Also See for M5:
Table of Contents

Advertisement

Unlocking
Grasp a door handle fully, refer to arrow 1, but
do not touch the surfaces, arrow 2 or 3 when
doing so. This corresponds to pressing the
button.
Locking
>
On the driver's door, touch the highlighted
surface, arrow 2, with a finger for approx.
1 second, but do not grasp the door handle.
>
On the remaining doors, touch the high-
lighted surface, arrow 3, with the back of
your hand for approx. 1 second, but do not
grasp the door handle.
This corresponds to pressing the
ton.
To preserve the battery, please make
sure that the ignition and all electrical
consumers are switched off before locking the
vehicle.<
Comfort closing
Hold a finger or the back of your hand against
the surface, arrow 2 or 3, but do not grasp the
door handle while doing so.
The windows and the glass sunroof
closed.
Watch during the closing process to be
sure that no one is injured. Removing the
hand from the door handle stops the closing
process
immediately.<
Opening luggage compartment lid
separately
Press the button on the luggage compartment
lid. This corresponds to pressing the
34
Online Edition for Part no. 01 41 2 602 697 - © 08/09 BMW AG
Online Edition for Part no. 01 41 2 602 697 - © 08/09 BMW AG
If the vehicle detects that a remote con-
trol has been accidentally left inside the
locked vehicle's cargo area after the luggage
compartment lid is closed, the lid will reopen.
The hazard warning flashers flash and a signal
sounds.<
Switching on radio readiness
By pressing the Start/Stop button, you switch
on the radio readiness, refer to page 51.
When doing so, do not depress the brake
or clutch pedal, otherwise the engine will
start
immediately.<

Starting engine

You can start the engine or switch on the igni-
tion if a remote control is located in the interior
of the vehicle. It need not be inserted in the igni-
tion lock, refer to page 51.
If you take the remote control with you when
leaving the vehicle with the engine running, a
warning lamp lights up. In addition, a message
appears on the Control Display. As long as no
remote control is detected, it is only possible to
but-
restart the engine within approx. 10 seconds
after it is switched off.
Malfunction
The Comfort Access function may malfunction
due to local radio waves. Then open or close the
vehicle with the buttons on the remote control
or with a key. To start the engine following this,
insert the remote control in the ignition lock.
When unlocking or locking/comfort closing do
not simultaneously grasp the door handle and
*
are
touch the surfaces, arrow 2 or 3. Otherwise, you
may limit the function.
Replacing battery
If the battery of the remote control is dead, a
message will appear in the Control Display.
button.
*

Advertisement

Table of Contents
loading

Table of Contents