Button Operation - JOBO Smartcam Nano User Manual

1.5 Button operation

You can operate the camera alone without connecting to a mobile
device via Wi-Fi/App. See the table below for a description of each
button's function.
Item
Mode button
Record button
Wi-Fi button
Power button
Note:
If you want the recorder to go back to the Default Setting, make sure the camera's Wi-Fi is
turned off. Press and on-hold the Mode button, then press the Wi-Fi button, when the beep
tone is promoted, which indicates the completion of factory settings.
8
Changing Modes (Timelapse / Capture / Recording
Mode)
• • • • In Timelapse mode, press the Record button to
start recording a video. Press it again to stop
recording (When the device enters Power Saving
Mode and is in shutdown status, press the Power
button to stop recording).
• • • • In Camera mode, press the Record button to
capture a photo.
• • • • In Video mode, press the Record button to start
recording a video. Press it again to stop recording.
Press to turn the Wi-Fi on or off.
• • • • Press to turn the camera on or off.
• • • • To reset, press and hold the Power button for at
least 5 seconds.
Function