Getting Started; Connections And Powering - Vermona Retroverb Lancet Owner's Manual

Getting Started

To ensure top quality we carefully checked Retroverb Lancet before packag-
ing. Nevertheless, the unit could have been damaged during transportation.
Therefore, we ask you to take a serious look at the unit when unpacking it.
Do not hesitate to contact us, should there be anything unusual on Retro-
verb Lancet itself or its packaging.
You should find the following items in the box:
• 1 Retroverb Lancet unit
• 1 AC adapter (12V / at least 830mA)
• this manual

Connections and Powering

If you came here without any problems, you can finally start up your Retro-
verb Lancet:
1. Connect the provided power supply unit to the 12VAC jack on Retro-
verb Lancet
ATTENTION
2. Connect the INPUT jack of Retroverb Lancet to an appropriate audio
source such as a drum-computer, a groove-box, a synthesizer, a gui-
tar or CD-player.
3. Connect the OUTPUT jack of Retroverb Lancet to an appropriate audio
input of a mixing console, an audio-interface or an amplifier.
4. Start Retroverb Lancet by switching on OVERKILL on the unit's rear.
The corresponding green LED will be lit.
5. Congratulations, Retroverb Lancet has been started.
Owner's Manual VERMONA Retroverb Lancet
Only use the included power supply! You may already
own a suitable-looking power supply that offers the
same connector.
an AC adapter, not DC!
supply may cause damage to the unit.
However, Retroverb Lancet requires
Using an unsuitable power
- 5 -