Table of Contents
Advertisement
SUPPORT ROD
4-cylinder models
3. Pull the support rod out of its clip
and insert the end into the hole on
the front of the hood around the
center.
To close the hood, lift it up slightly to
remove the support rod from the
hole. Put the support rod back into
its holding clip. Lower the hood to
about a foot (30 cm) above the
fender, then let it drop.
After closing the hood, make sure it
is securely latched.
Service Station Procedures
6-cylinder models
3. Lift the hood up most of the way.
The hydraulic supports will lift it
up the rest of the way and hold it
up.
Before Driving
CONTINUED
Advertisement
Chapters
Table of Contents
