LG HBLG1004R Service Manual page 16

Disassembly
10. Power Cord
1. Remove the control box. (Refer to section 3)
2. Open the top cover from the control box.
(Refer to section 9)
3. Disconnect the front panel from the control box.
(See Figure 22)
4. Disconnect two leads from the capacitor and
relay.
5. Pull out the power cord.
6. Re-install the component by referring to the
above removal procedure, above.
(Use only one ground-marked hole for ground
connection.)
7. If the supply cord of this appliance is damaged, it
must be replaced by the special cord.
(The special cord means the cord which has the
same specification marked on the supply cord
attached at the unit.)
11. Motor
1. Remove the cabinet. (Refer to section 2)
2. Remove the turbo fan. (Refer to section 4)
3. Remove the fan. (Refer to section 5)
4. Remove the 4 screws that fasten the motor from
the air guide. (See Figure 23)
5. Remove the motor.
6. Re-install the components by referring to the
removal procedure, above.(See Figure 23)
16 Room Air Conditioner
Figure 22
Figure 23