Disassembly; Mechanical Parts - LG HBLG1004R Service Manual

Disassembly

— Before the following disassembly, set the CONTROL BOX to OFF and disconnect the power cord.

Mechanical Parts

1. Front Grille
1. Open the lnlet grille downward and remove the air filter.
2. Remove the screw that fastens the front grille.(See
Figure 12)
3. Pull the front grille from the right side.
4. Remove the front grille.(There are 4 hooks.)
5. Re-install the components by referring to the removal
procedure, above.
2. Cabinet
1. After disassembling the FRONT GRILLE, remove the 6
screws that fasten the cabinet at both sides.
2. Remove the 2 screws that fasten the cabinet at back.
3. Lift the cabinet from the unit.
4. Remove the cabinet.
5. Re-install the components by referring to the removal
procedure, above.
3. Control Box
1. Remove the front grille. (Refer to section 1)
2. Remove the cabinet. (Refer to section 2)
3. Remove the 1 screw which fasten the power cord.
4. Disconnect the grounding screw from the evaporator
channel.
5. Remove the 2 screws that fastens the control box cover.
6. Remove the housing that connects PCB and motor
wire in the control box.
7. Remove the nut that fastens the terminal cover.
8. Remove the terminal cover.
9. Remove all the leads from the overload protector.
10. Discharge the capacitor by placing a 20,000 ohm
resistor across the capacitor terminals.
11. Raise the control box upward completely.
(See Figure 14)
12. Re-install the components by referring to the removal
procedure, above.
(Refer to the wiring diagram found on page 21 in this
manual and on the control box.)
Figure 12
Figure 13
Figure 14
Service Manual 13
Disassembly