Installation; Select The Best Location; Installation Check; How To Secure The Drain Pipe - LG HBLG1004R Service Manual

Room air conditioner
Table of Contents

Advertisement

Installation

Installation

Select the Best Location

1. To prevent vibration and noise, make sure the unit is installed
securely and firmly.
2. Install the unit where the sun does not shine directly on the
unit.
3. The outside of the cabinet must extend outward for at least
12" and there should be no obstacles, such as a fence or
wall, within 20" from the back of the cabinet because it will
prevent heat radiation of the condenser.
Restriction of outside air will greatly reduce the cooling effi-
ciency of the air conditioner.
CAUTION:
All side louvers of the cabinet must
remain exposed on the outdside of the structure.
4. Install the unit slanted slightly so the back is slightly lower
than the front (about
to the outside.
5. Install the unit with the bottom about 30"~60" above the
floor level.

Installation Check

The setting conditions must be checked prior to initial starting.
The following items are especially important checking points when the installation is finished.
1. Grounding wire (Green or Green and Yellow) is provided in the power cord. The green wire must be grounded.
2. Connect to a single-outlet 15A circuit.
(or 20A circuit for Electric Heater Model)
3. To avoid vibration or noise, make sure the air conditioner is installed securely.
4 Avoid placing furniture or draperies in front of the air inlet and outlet.

How to Secure the Drain Pipe

In humid weather, excess water may cause the Base Pan to
overflow. To drain the water, remove the Drain Cap and secure
the Drain Pipe to the rear hole of the Base Pan. (Figure. 2)
8 Room Air Conditioner
/
"). This will force condensed water
1
4
INSIDE
OUTSIDE
COOLED AIR
Drain Pipe
Drain Cap
FENCE
AWNING
HEAT
RADIATION
ABOUT / "
1
4
Over 20"
Figure 1
Figure 2

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents