Table of Contents
Related Manuals for Charnwood W413
Summary of Contents for Charnwood W413
- Page 1 12” DISC SANDER OPERATORS MANUAL MODEL: W413 Charnwood, Cedar Court, Walker Road, Hilltop Industrial Estate, Bardon Hill, Leicestershire, LE67 1TU Tel. 01530 516 926 Fax. 01530 516 929 email: sales@charnwood.net website: www.charnwood.net...
-
Page 2: General Safety Rules
GENERAL SAFETY RULES WARNING: Do not attempt to operate the machine until you have read thoroughly and understood completely all instructions, rules, etc. contained in this manual. Failure to comply may result in accidents involving fire, electric shock, or serious personal injury. Keep this owner's manual and review frequently for continuous safe operation. - Page 3 14. Maintain the machine in good condition. Keep the machine clean for best and safest performance. Follow instructions for lubrication and changing accessories. 15. Disconnect the machine from power source before servicing and when changing the blade. 16. Never leave the machine running unattended. Turn the power off. Do not leave the machine until it comes to a complete stop.
-
Page 4: Specification
15. Do not modify this machine in any way or use it or anything other than its designated purpose. Neither the manufacturer nor the suppliers will be liable for any damage or injury caused by incorrect assembly, operation or electrical connection of this machine. -
Page 5: Using The Sander
Unpacking Open the carton, carefully unpack all of the contents and lift the sander onto a bench. In addition to the sander you will find three spanners, a screwdriver and this instruction manual. Assembly This machine is supplied fully assembled. It is recommended that you bolt or screw it down to a work bench or suitable stand. - Page 6 There is a scale on the trunnion, for accurate angle setting of the table. If necessary, the pointer may be adjusted by loosening the small screw holding it in place. To switch the sander on or off, slide the red section of the cover back.
- Page 7 Disc Removal and Replacement There are two bolts securing the dust collection hood, remove them both. Remove the two bolts which secure the disc cover to the base. Remove the two bolts fixing the disc cover to the motor. Lift the disc housing, complete with table, off the machine and set it to one side.
-
Page 8: Optional Items
More information can be found on our website www.charnwood.net The sander is supplied with a 300mm diameter self-adhesive backed sanding disc. These are available from Charnwood in differing grit sizes, from 60 to 150. Velcro Disc System An alternate to using self-adhesive discs is to use Velcro backed discs. -
Page 9: Troubleshooting
Check the disc plate is tight on the shaft Check the disc plate is not warped Declaration of Conformity for CE Marking Charnwood Declare that woodworking disc sander, Model W413 Conforms with the following Directives: Machinery Directive 2006/42/EC Low Voltage Directive 2006/95/EC EMC Directive 2004/108/EC And further conforms to the machinery example for which the EC type examination Certificate No. - Page 10 CHARNWOOD W413 EXPLODED DIAGRAM...
- Page 11 CHARNWOOD W413 PARTS LIST Item Part Item Part Base Hex head set screw M8 x 16 Motor base Hex head set screw M6 x 12 Motor Washer Disc Cover Guard Disc Rd head set screw M5 x 8 Hex head set screw M6 x 10...
- Page 12 Charnwood, Cedar Court, Walker Road, Hilltop Industrial Estate, Bardon Hill, Leicestershire, LE67 1TU Tel. 01530 516 926 Fax. 01530 516 929 email: sales@charnwood.net website: www.charnwood.net...