Vertex Standard VX-230 Series Service Manual page 14

Alignment
4. TX P
OWER
This parameter is to align the "Power High" or "Power Low" for the selected channel.
1. Click the "POWER (H)" or "POWER (L)" button to open
the Power Alignment window.
2. Click the "PTT" button on the desired frequency which you
wish to alignment. The radio starts to transmit on selected
frequency.
3. Set the value to get desired output power (High: 5W, Low:
1W) on the Power meter by the following ways:
 Drag the slide bar
 Click the up/down button
 Press the left/right arrow key of the computer's keyboard
 Enter the value in the "Data" box from the computer's
keyboard.
4. After getting the desired output power, click the "PTT" but-
ton to stop the transmit.
5. Click the "OK" button to finish the TX Power alignment and
save the data.
You may select the alignment type from the Radio button (ADJ
Type) located at the bottom of the screen, as needed.
ADJ Type
Single : Alignment value change only to selected channel.
All Freq : Alignment value change for connecting with other
channels.
VX-230 Series UHF FM Transceiver Service Manual 14