Pioneer XV-EV1000 Service Manual page 113

5
2
Front Panel, Amplifier Assy and
DSP Board diagnosis
1
Remove 4 screws at bottom side of the unit.
1
Bottom View
2
Remove the grounding screw.
3
Unhook the 2 cable hooks.
4
Released the hook at the right and left side of the Front
Panel Assy.
3
2
5
6
4
Front Panel Assy
6
7
Do not remove this cable, once removed,
there is no amplify output signal, you need
to use the headphone to hear the output signal.
Do not remove this cable, once removed,
the display will indicate "Mic in"
and you cannot select 5.1 channel output signal,
only 2 channel signals will be output.
Not affected for model with 2 channel output.
(But display will also indicate "Mic in")
5
In the event that Power Amplifier Assy was removed and
repaired(IFAF Assy had been removed)
If you want to power on the set with IFAF Assy removed
from the Rear Panel, make sure both the DSP and RCA
grounds are connected to the Rear Panel as shown in
the attached photo.
C
IFAF Assy
XV-EV1000
7
8
A
B
C
D
DSP Ground
E
RCA Ground
Rear View
F
113
8