Table of Contents
Advertisement
MOUNTING THE APPLIANCE
PRIOR TO CONNECTING
C
on the rating plate cor-
HECK THAT THE VOLTAGE
responds to the voltage in your home.
D
O NOT REMOVE THE MICROWAVE INLET PROTECTION
located on the side of
PLATES
the oven cavity wall. They
prevent grease & food par-
ticles from entering the mi-
crowave inlet channels.
E
the oven cavity is
NSURE
empty before mounting.
E
NSURE THAT THE APPLIANCE IS NOT DAMAGED
that the oven door closes fi rmly against the
door support and that the internal door seal is
not damaged. Empty the oven and clean the
interior with a soft, damp cloth.
AFTER CONNECTING
T
HE OVEN CAN BE OPERATED ONLY
fi rmly closed.
T
HE EARTHING OF THIS APPLIANCE
The manufacturer will accept no responsibili-
ty for injury to persons, animals or damage to
objects arising from the non-observance of
this requirement.
2
INSTALLATION
F
OLLOW THE SUPPLIED
structions when installing the appliance.
D
O NOT OPERATE THIS APPLIANCE
mains cord or plug, if it is not working proper-
ly, or if it has been damaged or dropped. Do
not immerse the mains cord or plug in water.
Keep the cord away from hot surfaces. Electri-
cal shock, fi re or other hazards may result.
D
O NOT USE EXTENSION CORD
. Check
if the oven door is
T
HE FIRST TIME THE OVEN IS SWITCHED ON
asked to set the language and current time.
is compulsory.
Follow the instructions under the headline
"Changing settings" in this instructions for use.
The appliance is ready to use after these two
steps have been taken.
The manufacturers are not liable for any
problems caused by the user's failure to
observe these instructions.
separate mounting in-
if it has a damaged
:
I
F THE POWER SUPPLY CORD IS TOO SHORT
qualifi ed electrician or serviceman install
an outlet near the appliance.
, have a
, you will be
Advertisement
Table of Contents
