Step 2: Load The Print Media - Lexmark Z12 User Manual

Step 2: Load the print media

Load up to:
100 sheets of plain paper
10 envelopes
10 greeting cards, index
cards, or postcards
25 transparencies
25 iron-on transfers
20 sheets of banner paper
100 sheets of custom size
paper
•
•
2
Chapter 1
•
•
•
Note: See page 3 for instructions on loading banner paper.
1 Place the media against the right side of the sheet feeder.
Follow these guidelines when loading print media:
Make sure:
• The print side is facing you.
• The print side is facing you.
• The envelopes are loaded vertically against the
right side of the sheet feeder.
• The stamp location is in the upper left corner.
• The print side is facing you.
• The cards are loaded vertically against the right side of the sheet feeder.
• The rough sides of the transparencies are facing you (smooth side down).
• You follow the instructions on the packaging to load the iron-on transfers.
• You follow the directions for printing banners on page 3.
• The print side is facing you.
• Your paper size fits within these dimensions:
- Width: 76 mm to 216 mm (3.0 in. to 8.5 in.)
- Length: 127 mm to 432 mm (5.0 in. to 17.0 in.)
2 Squeeze the tab on the paper guide and slide the paper guide
to the left edge of the media.
Sheet feeder
Paper guide
Paper alignment
marks