Before Recording; Dubbing Setting - Yamaha RX-E600 Owner's Manual

Before recording

When you record by using MDX-E300 or KX-E300, you
must first make the connections as shown in "Connecting
the system" on page 5. For details, refer to the instructions
supplied with the MDX-E300 or KX-E300. A source from
the component which is connected to the AUX terminal
component can be recorded on a tape or MD.

Dubbing setting

There are six different combinations of components. Once
you choose a certain mode, recording starts and ends
automatically in a certain way for each mode.
PRESET
MD
MD
REC/PAUSE
MODE
DUBBING
MODE
SLEEP
1
Decide the combination of the components. Each
time you press DUBBING MODE, the mode will
change in the below order.
1
• Recording automatically starts from the beginning
of the tape. (By pressing DUBBING START, the
tape automatically rewinds to the beginning if it is
in the middle.)
• When the recording on side A finishes while a
track is being played back, the recording on side B
starts from the beginning of the same track.
• The sound is automatically faded out when it gets
close to the end of side B.
0111CRXE400(M).17-19.E
TAPE
DIRECTION
TUNER PRESET
DVD TAPE
AUX
TAPE
REC/PAUSE
DUBBING START
DUBBING
START
DISPLAY
VOLUME
19
SYSTEM CONTROL
2
3 Play unit Record unit
• Same as CD = TAPE
Play unit
4
• Recording automatically starts at the beginning of
the tape. (By pressing DUBBING START, the
tape automatically rewinds to the beginning if it is
in the middle.)
2
Press DUBBING START to start recording.
Note
• The displays 1~4 which include the component you have
not connected to your receiver (RX-E600) will be skipped.
To stop dubbing
Press &.
2004.06.15, 19:10
Record unit
19