Optional Settings For Rds Functions - Yamaha RX-E600 Owner's Manual

RECEIVING RDS STATIONS
Optional settings for
RDS functions
The tuner has the following functions which make use of
the RDS data service. These are originally in operation
ON. However, you can turn these functions OFF, if so
desired.
1
1
4
4
7
PTY SEEK MODE
7
0
FREQ/RDS
FREQ/RDS MODE – PTY SEEK – START
REP
A
D
PRESET
TUNER
MD
MD
REC/PAUSE
MODE
SLEEP
1
Select the FM band by pressing TUNER.
2
Press DISPLAY to display the current time.
3
Press FREQ/RDS.
4
Each time you press PTY SEEK MODE the display
will change as follows:
1. CT = CLOCK (ON/OFF)
The tuner corrects the time of the built-in clock
automatically by synchronizing it with the CT
data on the RDS station being received.
14
0107CRXE400(M).12-14.E
POWER
2 3
2 3
5 6
5 6
8 9
8
+10 +100
PTY SEEK START
RANDOM PROG
B C
TIME
E
TAPE
DIRECTION
TUNER PRESET
TAPE
DVD
AUX
TAPE
REC/PAUSE
DUBBING START
DISPLAY
DISPLAY
VOLUME
14
• If you receive an RDS station of some other
country, the built-in clock is synchronized with
the time setting of the country.
• If the built-in clock is not yet set for the current
time or reset due to a power failure, etc., it will be
set for the time of the CT data automatically,
whether this setting is ON or OFF.
2. LOCAL = CT (ON/OFF)
If the RDS station being received employs the
local time (summer time, etc.) data service, its
time is displayed in the CT mode.
3. A.M. = RDS (ON/OFF)
RDS stations are searched instead of all FM
stations by the automatic preset tuning operation
when the setting is ON. (Refer to page @11.)
4. RT SPEED: ±0
Changes the scrolling speed of the radio text
decreasing the value and, in turn, reducing the
speed.
Control Range: ±0 to ±3 (Preset value: ±0)
5
Choose the function ON or OFF by pressing PTY
SEEK START, confirming it in the display. Press
PTY SEEK START repeatedly to change the value
for RT SPEED.
• If there is no operation for about 20 seconds, this
mode is cancelled and turns into the frequency
display. If the station has PS data, it turns into the
PS mode.
6
Press FREQ/RDS again to restore the frequency
display mode.
2004.06.15, 19:09